-
-
December 5, 2024 at 4:48 pm
jianing2016
SubscriberHello Friends,
Is there any way to re-mesh the model to kill some over-stretched elements during a simulation on explicit dynamic simulation?Â
Thank you!
-
December 6, 2024 at 11:57 am
mohan.urs
Ansys EmployeeHey,
There are ways to erode off the elements based on some criterias like strain, principal stress etc. Check out this linkÂ
11.11. Failure
You can check out this course which shows any example of the same. Stochastic Material Failure Model | Ansys CoursesAlso check out this discussion as some of the concepts required are discussed in more detail.
Questions on Explicit Dynamics SettingsRegards,
Mohan Urs
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
Top Contributors
-
3407
-
1057
-
1051
-
896
-
877
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.