Learning Forum

[jianing2016]

Hello Friends,

Is there any way to re-mesh the model to kill some over-stretched elements during a simulation on explicit dynamic simulation? 

Thank you!

[mohan.urs]

Hey,

There are ways to erode off the elements based on some criterias like strain, principal stress etc. Check out this link 
11.11. Failure
You can check out this course which shows any example of the same. Stochastic Material Failure Model | Ansys Courses

Also check out this discussion as some of the concepts required are discussed in more detail.
Questions on Explicit Dynamics Settings

Regards,
Mohan Urs