Problem with axisymmetric analysis in Mechanical

- July 19, 2024 at 5:48 pm
  
  ChrisD
  Subscriber
  
  Hi, I am having trouble with 2D geometry coming into Mechanical from Spaceclaim for the purpose of axisymmetric analysis. See attached. It seems Ansys might be complaining that my planar sketch has a z-component, but you can see from the figure that it is zero. Thank you!
- July 22, 2024 at 9:40 am
  
  Sampat Kumar
  Ansys Employee
  
  Hi Chris,
  Trouble with Axisymmetric Analysis (ansys.com)
  A duplicate question has been created. Follow the above link for further discussion.
  If you have a question related to the Ansys WB (FEA), ask in the General Mechanical section that I mentioned below.
  General Mechanical (ansys.com)
  
  Best Regards,
  Sampat