We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
Ansys Products

Ansys Products

Discuss installation & licensing of our Ansys Teaching and Research products.
  1. All Channels
  2. Ansys Products
  3. Error: Coupled solution is out of sync (Icepak – Maxwell – two way coupling)

Error: Coupled solution is out of sync (Icepak – Maxwell – two way coupling)

    • April 18, 2024 at 7:05 am
      david.cravo
      Subscriber

      Hello everyone,
      I want to run a two way coupling simulation of this two coils (shown below).
      Maxwell simulation runs perfectly without the coupling. Icepak is also running without Maxwell. 

      But evertime I do the two way coupling I got this error message.

      This is not only with this geometry but also with other geometries I tried. Could anyone guide me in the right direction?



      Best regards

    • April 22, 2024 at 12:56 pm
      Pdev
      Ansys Employee

      Hi David, 

      Thanks for reaching out. We will need to look at your set up in detail. Please file a ticket with customer support (ACSS) and we will be happy to assist you. Thanks!

      Best,
      Pdev

Viewing 1 reply thread
  • The topic ‘Error: Coupled solution is out of sync (Icepak – Maxwell – two way coupling)’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.