ANSYS MAXWELL Error:-process solver2d error

- September 1, 2020 at 6:07 pm
  
  Bobby11
  Subscriber
- September 2, 2020 at 12:54 pm
  
  NKC
  Forum Moderator
  
  Hi,
  It looks like some objects in geometry are intersecting.
  Check for any interference.
  Check for proper Band definition for all the rotating objects in the geometry.
  Define band by drawing a polygon with multiple segments and also an additional dummy object (polygon) between rotor and band for better meshing.
  
  Regards
  Navya
- September 3, 2020 at 5:32 pm
  
  Bobby11
  Subscriber
  
  .
  Dear Sir,
  After going through your steps, now I am getting following error...:
  "Time step at 0 sec completed, process solver2d error: Internal Solver Error: 'MFS Solver failed: Find Factorization fail"
  "Simulation completed with execution error on server: Local Machine. "
  
  .
- July 12, 2021 at 10:36 pm
  
  JAVED
  Subscriber
  
  .
  try with bigger mesh elements. it worked for me.
  .
- December 11, 2021 at 11:19 am
  
  nitishsharma
  Subscriber
  
  .
  i am also getting same error, i have checked interference and band , but i am not able to figure out what is the problem.
  please help me
  .
- February 17, 2022 at 12:34 am
  
  AAPM
  Subscriber
  
  .
  Hi,
  I'm trying to simulate a Synchronous reluctance motor with Ferrite magnet. which material should be selected for Ferrite magnet? is ceramic the appropriate material in this case?
  Thanks a lot
  .
- February 17, 2022 at 12:48 pm
  
  Bobby11
  Subscriber
  
  .
  AAPM I used Y30BH, its a ferrite magnet. You may also use rare earth magnet (NdFeB)
  .