Learning Forum

[ciro.cuozzo]

Hello, I am performing an in-flight icing multishot simulation of a 3D wing (half-wing due to symmetry) within Fluent Icing. 

I have no problems with Airflow, Droplets and Ice solution. However, after the ice computation, during the remeshing process (with standard settings and therefore the default journal remesh_run), I get warnings and the following errors:

Has it happened to someone or someone knows how to solve this?

Thanks in advance. 

[Federico]

Hello, 

Did you follow our guidelines for using Remeshing?

For example, you need to assign proper sizing controls for the new mesh. Also, what did you use for the Airflow part? If you used Fluent, there are some requirements in the naming of the different zones.

You can read on the requirements for Fluent Meshing here: 10.2.4. Multishot with Remeshing