Ansys Assistant will be unavailable on the Learning Forum starting January 30. An upgraded version is coming soon. We apologize for any inconvenience and appreciate your patience. Stay tuned for updates.
Ansys Products

Ansys Products

Discuss installation & licensing of our Ansys Teaching and Research products.
  1. All Channels
  2. Ansys Products
  3. nCode – time series

nCode – time series

    • December 8, 2024 at 9:55 am
      Tom Ber
      Subscriber

      Hi,

      I am perform analysis in ncode using time series. I would like to set that my block time series corresponds to 50 cycles.

      Do you know where I can set this? 

      Thanks in advance 

      Tom

    • December 9, 2024 at 2:17 pm
      danielshaw
      Ansys Employee

      You could define the time series loading within a duty cycle and set 50 as the number of repeats or under Advanced Edit > PostProcessors>Compressed Results you could define an NumEquivUnits.

    • December 9, 2024 at 5:09 pm
      Dragana Jandric
      Forum Moderator

      If you are using the Time Series Input glyph, you can set Repeat Count to 50. 

Viewing 2 reply threads
  • You must be logged in to reply to this topic.
Innovation Space
Top Contributors

© 2026 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.
[bingo_chatbox]