General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. “Input Geometry Parameters – BladeGen – Francis Turbine”

“Input Geometry Parameters – BladeGen – Francis Turbine”

    • December 6, 2024 at 12:06 am
      giron9349
      Subscriber

      Buenos días,
      Where can I enter the major and minor diameter, inlet and outlet edges of a Francis turbine in BladeGen? Or, in which interface within ANSYS would it be easier to do so? Please help

    • December 6, 2024 at 1:37 pm
      Erik Kostson
      Ansys Employee

      Hi

      This is the forum for Mechanical (Structural applications).

       

      Post this in the fluids forum:

      https://innovationspace.ansys.com/forum/forums/forum/discuss-simulation/fluids/

       

      All the best

       

      Erik

Viewing 1 reply thread
  • The topic ‘“Input Geometry Parameters – BladeGen – Francis Turbine”’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.