Co-Simulation Issues

- October 4, 2023 at 9:58 pm
  
  Mathis Allen
  Subscriber
  
  I am having an issue with my Simulink/Twin Builder co-simulation where it won't initialize due to some problem with the meshing. Any ideas on how I can fix this? I am not able to turn off TAMU so I am unsure what to do. The target machine is an IPMSM in Maxwell 2D. The Twin Builder circuit is also shown below.
- October 6, 2023 at 7:03 pm
  
  DELI
  Ansys Employee
  
  Hi, the error message is about meshing in Maxwell, could you uncouple with Simulink/Twinbuilder and just simulate in Maxwell first? Does it have any error message?