Pentration issue in Static Structural while analyzing the deformation of a SM

- March 8, 2023 at 10:39 am
  
  111119079
  Subscriber
  
  The Hydroforming boundary conditions like Pressure and fixed support were given to the sheet metal, But after the anslysis the results are found to be inaccurate i.e., the sheet metal that is deformed is penetrated into the bottom die as shown in figure. Please help me with the appropriate Contact settings for this issue.
- March 9, 2023 at 10:33 am
  
  Ashish Khemka
  Forum Moderator
  
  Hi,
  Can you please share the details of your setup? Please see if the following link helps:
  Fundamental Topics in Contact | Ansys Innovation Courses
  Regards,
  Ashish Khemka
- March 13, 2023 at 6:36 am
  
  111119079
  Subscriber
  
  Here are the setup details, The fixed supports were given at the bottom of the die that is Target body. Please review it and suggest a solution