Thermal Analysis of a PMSM

- July 28, 2021 at 9:42 am
  
  Lukas8778
  Subscriber
  
  Hey there,
  I'm trying to conduct a 3D thermal analysis of a PMSM similar as in one of your youtube tutorials with a coupling from maxwell to mechancial.
  https://www.youtube.com/watch?v=miHEhcZJ8jQ
- July 29, 2021 at 11:12 am
  
  Navya C
  Ansys Employee
  
  Hi @Lukas8778 If you copy-pasted the design you should not be facing the issue. In fact, I never faced this issue.
  I suggest you check if you have hidden any object in maxwell before coying into Icepak.
  
  Regards Navya
- October 18, 2021 at 4:44 pm
  
  Nikhil Tamhankar
  Ansys Employee
  
  Hi @Lukas8778 Do you have a 3D component in your Maxwell design ? You might have to right click on that component, Edit Component which will open in a separate project in AEDT. Then press Ctrl A + Ctrl C to copy the geometry + materials and use Ctrl V to paste the geometry in Icepak or Mechanical (Thermal) in AEDT. Then try again to run the solution. The geometry from Maxwell should be identical and in exact same location as that of Maxwell to for the EM loss mapping to work.
- May 17, 2023 at 10:41 pm
  
  Abdelkrim Bouzid
  Subscriber
  
  Hello I hope you doing well
  I have the same problem and I copied and pasted, plus "failed to get presolved data"
  And the last one when I copied the geometry the sheets become unassigned.
  Those are my problems
  And thank you