-
-
August 30, 2024 at 6:16 am
-
October 2, 2024 at 5:58 pmHDLIAnsys Employee
Hello min el,
   1. Yes, you could find variables for Id/Iq, Ld/Lq in output variables after creating Maxwell model from RMpxrt. You could also use transient DQ option to calculate dq components.
   2. The power factor is related to inductance, and impact of dq current would be small in it.
HDLIÂ Â
Â
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- Polarization and Angle of Incidence Scan with Floquet ports in ANSYS HFSS
- How to create Lumped RLC in HFSS to match Circuit? (Simulate load as Lumped RLC)
- CPW resonant frequency HFSS Simulation
- EMA3D Current Source Problem
- Simplorer link to Maxwell transient
- Help on calculating port impedance Zpv using Field calculator under HFSS please
- HFSS Incident Plane Wave excitement mode
- Question for Maxwell
Top Contributors
-
1116
-
468
-
440
-
225
-
201
Top Rated Tags
© 2024 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.