0 of 10 Questions completed
Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Unfortunately, you did not pass the quiz.
Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
Congratulations, you have passed the quiz!
You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
Congratulations, you have passed the quiz!
You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
Congratulations, you have passed the quiz!
You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
Congratulations you have passed the quiz!
You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.
Which meshing method is used to generate mesh on the gasket?
Which of the following statements is true?
What type of Connections are used in this assembly?
In case of the gasket, where does the maximum Total Deformation occur at the end of the solution?
What is the maximum Equivalent Stress (von-Mises) occurring on the gasket for the current case?
In the current case, what is the tension in the Bolt at time = 2s?
Which component shows has the region with the highest Equivalent Stress (von-Mises) occur?
If the Bolt Pretension is increased to 2000 N (and all other loads are kept constant), then the maximum Equivalent Stress (von-Mises) in the assembly, is _____.
If the Bolt Pretension is increased to 2000 N (and all other loads are kept constant), then the maximum Contact Pressure on the gasket is _____.
If the value of the Pressure load is increased to 5 MPa, keeping all other loads constant (i.e. Bolt Pretension is 1000 N), then maximum Equivalent Strain is _____.