We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
Ansys Products

Ansys Products

Discuss installation & licensing of our Ansys Teaching and Research products.
  1. All Channels
  2. Ansys Products
  3. WORKBENCH Mechanichal

WORKBENCH Mechanichal

    • October 12, 2024 at 2:32 am
      x526979
      Subscriber

      When a load is applied to the assembly model, it slips through. Please tell me to what to do about this.

      ↓The result showed the following message:

      One or more contact pairs exceed the small slip contact assumption.

      The non-converged solution (identified at substep 999999) is output for debugging the analysis.

       

    • October 14, 2024 at 2:56 pm
      dlooman
      Ansys Employee

      This may just be a graphical issue.  Try using True Scale.

Viewing 1 reply thread
  • You must be logged in to reply to this topic.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.