We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
Ansys Products

Ansys Products

Discuss installation & licensing of our Ansys Teaching and Research products.
  1. All Channels
  2. Ansys Products
  3. WORKBENCH Mechanichal

WORKBENCH Mechanichal

    • October 4, 2024 at 5:08 am
      x526979
      Subscriber

      Hi.Please teach me how do I set the deformed state to the initial state and  how to add another direction load from the set initial condition?

    • October 4, 2024 at 10:55 am
      Ashish Khemka
      Forum Moderator

      Hello,

      Please ssee if the following link helps you: 6.16. Geometry from Deformation Results (ansys.com)

      Regards,

      Ashish Khemka

    • October 7, 2024 at 5:02 am
      x526979
      Subscriber

      Thank you！　I have been solved.

Viewing 2 reply threads
  • You must be logged in to reply to this topic.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.