We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Innovation Space

FREE STUDENT SOFTWARE

What can I do simplify that curved surfaces in spaceclaim?

- May 4, 2024 at 9:08 am
  
  merveala01
  Subscriber
  
  I have a FSI project on exhaust manifold. before the meshing, it gives me that spline faces. I think I don't need to fix them. Does it cause to bad mesh quality?
- May 6, 2024 at 2:51 pm
  
  Federico
  Ansys Employee
  
  Hello Merve,
  the red region all seems fine for meshing except maybe at the top were the 2 splines are converging which might be difficult to fit in cells.

Viewing 1 reply thread

The topic ‘What can I do simplify that curved surfaces in spaceclaim?’ is closed to new replies.