-
-
November 27, 2024 at 12:41 pmsaransh.verma2810Subscriber
I am Conducting a WIG welding simulation in Transient Thermal to get temperature as a result and getting it approx 1300 degree Celsius which is fine. Now this result is imported as load in Transient Structural to calculate Residual Stress using mechanical boundary condition as fixed support. The result are not upto the mark as I am getting very high stress.Â
Please Help.
-
November 30, 2024 at 4:22 pmdloomanAnsys Employee
Are you assigning the weld body a "Reference Temperature" of 1300 degC in the Details for the body? That is what produces the residual stress.
-
December 1, 2024 at 11:45 amsaransh.verma2810Subscriber
I got the Temperature as output by entering moving heat source as input and using convection and radiation as thermal boundary conditions.Â
But I got my mistake and have accurate results nowÂ
Thank You
-
-
- The topic ‘Welding Simulation’ is closed to new replies.
- Problem with access to session files
- Ayuda con Error: “Unable to access the source: EngineeringData”
- At least one body has been found to have only 1 element in at least 2 directions
- Using APDL to extract stresses on a beam element.
- How to select the interface delamination surface of a laminate?
- Geometric stiffness matrix for solid elements
- Error when opening saved Workbench project
- Timestep range set for animation export
- Computation Accleration
- SMART crack under fatigue conditions, different crack sizes can’t growth
-
1156
-
488
-
486
-
225
-
201
© 2024 Copyright ANSYS, Inc. All rights reserved.