We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Innovation Space

FREE STUDENT SOFTWARE

Trouble Getting Output in Interconnect in Lumerical

- October 28, 2024 at 4:10 pm
  
  sajadi.ee.sut
  Subscriber
  
  Hello everyone,
  I'm using the Interconnect mode in Lumerical and have set up a simple circuit.
  However, despite checking all connections and initial settings, I'm unable to get any output from my simulation. Could someone guide me on the settings or steps I might be missing to resolve this issue?
- October 29, 2024 at 11:24 am
  
  Niki Papachristou
  Ansys Employee
  
  Hi Sajadi,
  Thank you for reaching out to us! There are several reasons this might be happening. One could be that you have checked the display results at ONA ans then you get the gain. Another reason could be that you have selected 100/0 at your splitter combiners. Additionally you can check your circuit without the modulator to check if it works without it.
  Please note that this is the optics forum and not the photonics where lumerical related question are posted. For your next lumerical question please post at: Ansys photonics forum
  Kind Regards,
  Niki

Viewing 1 reply thread

You must be logged in to reply to this topic.