-
-
May 23, 2023 at 1:30 pmfth987Subscriber
Hi, I need to define fire load according to changing time steps in transient analysis. There are 10 fire loads in terms of MW. How can I do it
-
May 23, 2023 at 4:23 pmRobForum Moderator
Assuming it's a source, have a look at Expressions, or a UDF.Â
-
May 23, 2023 at 4:41 pmfth987Subscriber
Yes it is a source. If there is a workshop on this, can you send it to me?
-
May 24, 2023 at 9:06 amRobForum Moderator
I don't think there is, have a look in Fluent's Help and under the Courses (including Knowledge materials) on here.Â
-
Viewing 3 reply threads
- The topic ‘to define fire load according to changing time steps in transient analysis’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- error udf
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- Fluent fails with Intel MPI protocol on 2 nodes
- Cyclone (Stairmand) simulation using RSM
- Diesel with Ammonia/Hydrogen blend combustion
- Non-Intersected faces found for matching interface periodic-walls
- Mass Conservation Issue in Methane Pyrolysis Shock Tube Simulation
- Encountering Error in Heterogeneous Surface Reaction
- How to obtain axial and tangential velocity in CFX-post?
Top Contributors
-
1156
-
471
-
468
-
225
-
201
Top Rated Tags
© 2024 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.