-
-
September 27, 2017 at 11:19 amnselvaraAnsys Employee
How to take reference of adjacent geometry while creating new edge/face?
-
October 17, 2017 at 7:47 amArun KumarSubscriber
While creating new edge or face, press "Alt" key and select the adjacent geometrical entities as reference. These selected entities are highlighted in blue color and are used as reference while creating new edge/face.
-
Viewing 1 reply thread
- The topic ‘Take reference of adjacent geometry while creating new edge/face’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- error udf
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- Diesel with Ammonia/Hydrogen blend combustion
- Fluent fails with Intel MPI protocol on 2 nodes
- Non-Intersected faces found for matching interface periodic-walls
- Encountering Error in Heterogeneous Surface Reaction
- Mass Conservation Issue in Methane Pyrolysis Shock Tube Simulation
- How to obtain axial and tangential velocity in CFX-post?
- Cyclone (Stairmand) simulation using RSM
Top Contributors
-
1131
-
468
-
455
-
225
-
201
Top Rated Tags
© 2024 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.