Required torque too large MotorCAD-ModelLab-OperatingPoint
-
-
Hello, I built a 6 phases induction motor in MotorCAD, but when I try to calculate a operating point in the ModelLab I have a problem with the torque. For example, with 30Nm, I obtain that required torque is too large, and MotorCad makes the calculations with 0Nm. I dont know what could be the problem, thank you.
-
-
Viewing 1 reply thread
- The topic ‘Required torque too large MotorCAD-ModelLab-OperatingPoint’ is closed to new replies.
You are navigating away from the AIS Discovery experience