-
-
December 6, 2020 at 1:13 pm
Refat
SubscriberI have problem in fluent solution. the problem is that the system can not reach to solution. The residual is unstable as shown in figure below .
December 7, 2020 at 1:28 pmKarthik Remella
AdministratornI'm moving this question over to the Fluids sub-category for better alignment.nInstead of attaching files for your post, could you please embed the screenshots directly into the post?nRegarding your first question, this is a typical convergence issue. Please provide us with some details about the simulation you are attempting to run (physics you are solving, quality of your mesh, Boundary conditions you are using, solver settings and so on) so we can help.nRegarding the 2nd question - please embed your screenshot directly into your post and we should be able to help.nThank you.nKarthiknViewing 1 reply thread- The topic ‘problem in Ansys fluent’ is closed to new replies.
Ansys Innovation SpaceTrending discussionsTop Contributors-
3472
-
1057
-
1051
-
929
-
896
Top Rated Tags© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.
-
The Ansys Learning Forum is a public forum. You are prohibited from providing (i) information that is confidential to You, your employer, or any third party, (ii) Personal Data or individually identifiable health information, (iii) any information that is U.S. Government Classified, Controlled Unclassified Information, International Traffic in Arms Regulators (ITAR) or Export Administration Regulators (EAR) controlled or otherwise have been determined by the United States Government or by a foreign government to require protection against unauthorized disclosure for reasons of national security, or (iv) topics or information restricted by the People's Republic of China data protection and privacy laws.