-
-
September 12, 2024 at 1:16 am
ebelechukwu.okeke
SubscriberI intend to use a periodic boundary condition; however, when I attempt to apply match control to my mesh, I encounter an error message stating: 'Selective body meshing is not recorded, so the meshing may not be persistent after an update. To record the order of body meshing, please use the worksheet to track the meshing step.' Despite multiple attempts to use the quality worksheet, I was unsuccessful. I proceeded to apply the periodic boundary condition, but I consistently receive a warning: 'Number of elements does not match between zone 11 and zone 12. Error: Failed to make zone periodic
-
September 16, 2024 at 1:29 pm
Rob
Forum ModeratorIs the geometry between the two periodic boundaries a single volume in the periodic direction?Â
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- How do I get my hands on Ansys Rocky DEM
- Non-Intersected faces found for matching interface periodic-walls
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Script Error
- Facing trouble regarding setting up boundary conditions for SOEC Modeling
- convergence issue for transonic flow
- Running ANSYS Fluent on a HPC Cluster
- Point exception in erosion calculation
- Errors with multi-connected bodies using AQWA
Top Contributors
-
1987
-
896
-
599
-
591
-
408
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.