Learning Forum

[a.montes]

Hi,

Is it possible to create a parameter with the number of copies in a circular pattern? See image below for reference:

 

Regards,

Antonio

[Devendra Badgujar]

Hello, 

Yes, you can do this using history tracking. You will have to first start History tracking before this step so that this geometry operation is recorded in blocks. You will than get option to parametrize number of copies. History Tracking in ANSYS Discovery - Ansys Knowledge

Let me know if this helps. Thanks! 

Regards,

Devendra 

[antoniogutgon]

Hi Devendra,

It seems that you can change and parameterize the circular pattern once it has been created. Below is a reference image.

Could you confirm that this is correct and that therefore it would not be necessary to use History Tracking?

Best regards,

Antonio

[Devendra Badgujar]

Hello Antonio, 

Yes, this is also a one of the approach of doing this. The parameters tab will be available once you have created the pattern:

Regards,

Devendra