NON MANIFOLD NODE WARNING

- May 15, 2024 at 7:54 am
  
  PRAVIN JONES RAJ
  Subscriber
  
  Hi guys.I am trying to run a simulation for fs car and during meshing the software send out an error saying non manifold node and then it does not generate mesh. Howto solve the issue? I have attached the geometry below.
- May 24, 2024 at 4:44 pm
  
  Devendra Badgujar
  Forum Moderator
  
  Hello PRAVIN,
  Can you please confirm if you are doing this simulation in Ansys Discovery?
  Regards,
  Devendra