We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. /NERR command issue in Harmonic Analysis

/NERR command issue in Harmonic Analysis

    • May 10, 2024 at 11:20 am
      vishal.payghan
      Subscriber

      Hi,

      I am facing error for solution termination due to warning messages more than 10000 while performing harmonic analysis in spite of using /nerr,,99999999 command.

      Any leads on this front?

      Thanks in advance.

    • May 10, 2024 at 1:10 pm
      Erik Kostson
      Ansys Employee

      Hi

      Similar issue - read through all posts below and hope that will help.

      /forum/forums/topic/nerr-command/

      All the best

      Erik

Viewing 1 reply thread
  • The topic ‘/NERR command issue in Harmonic Analysis’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.