named selections from meshing not being sent to Polyflow Solver

- November 20, 2017 at 2:18 pm
  
  bushrar
  Subscriber
  
  Hello,
  
  On one geometry I created, two of the named selections on "Meshing" do not carry into the Polyflow solver. I checked under the details of those Named Selections and it was already set to the default of "Send to Solver". In addition I was even able to send them to the Fluent Solver. So I was wondering how I can tackle this very specific Meshing-Polyflow communication problem?
  
  Thanks!
  
  bushrar
- November 24, 2017 at 7:33 pm
  
  Raef.Kobeissi
  Subscriber
  
  Hello Can you please show a picture of the 2 selections.
  
  Cheers
- November 27, 2017 at 2:23 pm
  
  bushrar
  Subscriber
  
  The parts labeled 'Disk Wall' and 'Disk Inlet' do not go from 'Meshing' to 'Polyflow' solver.
- November 27, 2017 at 8:43 pm
  
  Raef.Kobeissi
  Subscriber
  
  I am not sure about polyflow but when I do it in Fluent these surfaces are considered interfaces. Bodies that share surfaces.