Learning Forum

[shamik062]

Dear All,

I am trying to replicate a manual contact with object generation. There is only single Contact surfaces but six Target surfaces from six different parts. I have created named selection for both contact and target surfaces. But object generation method is creating nothing when I am trying to replicate the manual contact I have created. Where I am making mistake?

I have attached an image and my Ansys Files for reference. 

Thanks in advance.

[peteroznewman]

The Object Generator cannot make copies of an object when the same surface is on all objects.

You could imprint all the heads onto the top surface to make six faces on the top surface or ...

... just use the Named Selections to define a single contact definition.