Multizone and Sweep Method on two topological shared solid parst.

- November 12, 2024 at 7:22 pm
  
  jianing2016
  Subscriber
  
  Hello Friends!
  I met a problem on multizone and sweep method on two shared solid parts. Please see following photos.
  I have a spherical and donut shapes which are shared topologically. I want to mesh them with multi-zone for the center spherical and spherical "donut" disk in with sweep. However I can have both of them work. I only can have multizone on center spherical without sweep on donut.
  Attached with the whole parts, the error, and the the mesh settings.
  Thank you very much for your help!
- November 15, 2024 at 12:29 pm
  
  mohan.urs
  Ansys Employee
  
  Hey,
  Can you change the source and target selection to manual and select the bottom and top face of the donut as source and target. That should fix it.
  Regards,
  Mohan Urs