Learning Forum

[Andres Valencia]

Hi everyone

I am trying to model an Aorta. In inflation under the mesh mode, when selecting all the faces of the geometry except by 2 (the inlet and outlet) for the boundary box, and then hitting apply, the message "no selection" keep appearing, as shown in the photos.

However when I select less faces (for example 48), the boundary box accepts the value.

Could anyone explain me what am I doing wrong, or is it something about the ansys student version.

Thank you 

 

 

[peteroznewman]

It's not the Student version. The full version will behave the same.

[Andres Valencia]

so is it something I am doing wrong, how could I proceed