Electronics

Electronics

Topics relate to HFSS, Maxwell, SIwave, Icepak, Electronics Enterprise and more

maxwell results Ld,Lq and flux in twinbuilder.

    • Meroz
      Subscriber

      Hello, i'm trying to run a transient co-simulation in maxwell & twinbuilder for pmsm motor, and in order to set my closed control loop i will need the flux and d_q inductance values. is there a way to extract these values directly on twinbuilder without using lookup table and save the data in maxwell?

    • DELI
      Ansys Employee
      , Ldq doesn't not send to Twinbuilder, you can only read those value in Maxwell side. But you can get Idq and flux value in Twinbuilder side.
Viewing 1 reply thread
  • The topic ‘maxwell results Ld,Lq and flux in twinbuilder.’ is closed to new replies.