-
-
December 11, 2024 at 11:06 am
2022160206
SubscriberWhen using Matlab to link zemax for optimization, the memory gradually fills up. My purpose is to collect multiple HUD optical systems when optimizing HUD surface parameters. When I gradually collect more systems, the computer ram will gradually fill up (64g). I checked through the computer task manger, the RAM usage of zemax is gradually increasing (there is only one zemax process). Finally, when the ram is full, matlab will report an error and stop.
-
December 12, 2024 at 3:31 am
Dev
Ansys EmployeeHello, This forum is for Lumerical posts (Photonics). You can post this question in Optics forum.
Thanks
-
December 12, 2024 at 12:50 pm
Kirill
Ansys Employee -
January 29, 2025 at 2:48 pm
Niki Papachristou
Ansys EmployeeHi Subscriber,
I am not sure about the root of this problem. I would suggest to make sure that go through the PC requirements reported here: What computer should I buy to run OpticStudio?
Kind Regards,
Niki
-
- You must be logged in to reply to this topic.
- STEP File Exports
- Optic studio-zemax operand values are different from the plot (Genc and Denc)
- Assistance Needed for Wavelength Adjustment in Optical Ring Modulator Simulation
- Matlab linkage Zemax memory overflow problem
- Relay Lens Optimization
- Gaussian beam propagation and field by angle
- RMS Spot size in Non-Sequential Method in Zemax Opticstudio
- How to calculate Wavefront RMS when “Remove Tilt” is chosen in Wavefront Map?
- Issues opening Zemax files
- Zemax: creating an array of tilted source
-
2537
-
933
-
787
-
599
-
591
© 2025 Copyright ANSYS, Inc. All rights reserved.