-
-
April 26, 2024 at 5:35 amFady ElshazlySubscriber
Hello,Â
Â
I face a problem with the beam element in LSDYNA. As shown in the attached screenshot, the used thicknesses give me error termination. However if I make the first two thicknesses with any value smaller than the third and forth ones, the model solves without any problem (but this makes the section depth horizontal). I should have the thicknesses as shown to get the correct beam prism as shown. What would be the solution for this with taking into consideration having the section as shown.Â
Â
-
April 29, 2024 at 4:28 amPuneeth BagariaAnsys Employee
Hello Fady,Â
I cannot reproduce any error with such defintion. Can you please provide complete *PART and *SECTION_BEAM along with the lines of exact error that you get in d3hsp?ÂÂ
Thanks
Puneeth
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- Speed up simulation in HFSS
- RSS is disabled.
- ANSYS Mechanical won’t open and stays on Blank Gray Screen (Path environment va)
- ANSYS DISPLAY RESOLUTION PROBLEM
- ansys fluent error when opening it “unexpected license problem”
- Workbench license error
- Could not connect to a valid licensing server
- Ansys 2024 R1 – The installation completed with warnings/errors.
- Unexpected error on Workbench: Root element not found.
- LS-Dyna Beam elements outputs
Top Contributors
-
861
-
427
-
367
-
225
-
201
Top Rated Tags
© 2024 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.