We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. Lattice structure generation and exporting

Lattice structure generation and exporting

    • April 30, 2024 at 10:21 am
      hemanth kollipara
      Subscriber

      Hi, I am working on my thesis that involves generating lattice structures. Till now i was using different software for lattice generation in which I am facing difficulty in exporting the lattice structure after optimization. So here are a few queries that I would like to know
      1) Can I export lattice generated by ANSYS into CAD software ? (If so how?)
      2) Can I obtain a printable lattice structure after topology optimization in ANSYS? (If so how?)
      3) How does ANSYS generate lattice structure, is it based on CAE analysis or it produces lattice based on the type we select and make it best fit for the geometry?

    • May 2, 2024 at 7:26 am
      Ashish Khemka
      Forum Moderator

      Hi,

      Please see if the following link helps you:

      What are the key steps needed to perform and view lattice optimization? - Ansys Knowledge

      Regards,

      Ashish Khemka

Viewing 1 reply thread
  • The topic ‘Lattice structure generation and exporting’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.