TAGGED: 3D-layout
-
-
October 30, 2024 at 4:40 pm
-
November 1, 2024 at 11:35 pm
Rong Liu
Ansys EmployeeYes, it is normall that the dielectric fill is not visible, you can verify it by right clicking on HFSS setup in the project manager and choose export-->HFSS model and save it to a folder and then open that file. Now it is in the MCAD and all the dielectric fill is shown.
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- HFSS Incident Plane Wave excitement mode
- Ansys Maxwell 3D – eddy current
- Difficulty/Obstacle: “Parasolid entry check failed for part:”
- dq graph non-conformity
- Simplorer+Maxwell Cosimulation results and Maxwell results mismatch
- Maxwell circuit – PWM
- Ansys-MATLAB Co-Simulation
- Parametrizing coil “terminals” with coil geometry
- Plotting Ex, Ey and Ez in vector forms individually
- Calculating E-field tangential to a 2D resonant structure on a sapphire chip
Top Contributors
-
1987
-
896
-
599
-
591
-
408
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.