-
-
January 4, 2024 at 8:51 am
ctunceroglu
SubscriberHi, I am currently working on implementing the study attached to the link below, but unfortunately, I have been unable to achieve the expected results.
I have carefully followed the provided instructions, but it seems there might be some missing or unspecified points in the explanation that are causing discrepancies in my outcomes.Â
Thank you in advance for your time and support. I look forward to hearing from you soon.
Best regards
https://www.programmersought.com/article/81474266082/ -
April 2, 2024 at 6:50 am
NKC
Forum ModeratorUnfortunately this question is beyond the scope for ANSYS employees to answer on a public forum, so hopefully other users can chime in.
-
April 18, 2024 at 5:44 pm
Ben Watson
SubscriberHi Cagdas, you mentioned that you were not able to achieve the expected results. Can you provide some explaination and screenshots of where/how your results are different?
-
- The topic ‘induction coil gun simulation’ is closed to new replies.
- Y wiring method and the start and end points of winding.
- Lumped Port Deembed
- Optimizing Via Impedance in Ansys HFSS 3D Layout Using Geometric Parameter Sweep
- Hfss 3D pcb via capped and filled with epoxy
- AEDT Natural Convection with default correlation is failing solver initializatio
- HFSS libnvidia-ml.so too old or could not be found – Warning in slurm job output
- Three-Phase Voltage Imbalances in dual stator electric generator
- STL Import Errors in HFSS After Cleaning in SpaceClaim
- Calc Error in Field Calculator after PyAEDT Analyze
- import file autocad 3d
-
3882
-
1414
-
1241
-
1118
-
1015
© 2025 Copyright ANSYS, Inc. All rights reserved.