TAGGED: AEDT-ICEPAK, ansys-icepak, icepak-thermal
-
-
October 18, 2024 at 6:47 am
vignesh.j
SubscriberHi,
I am using icepak to study the temperature and flow behaviour of electronics enclosure. I have followed all the preprocessing steps to initiate the problem setup.
Before the 1st iteration, the solution is stoping with error "Solver iteration failed. May be solution is diverging". Please let me know why this issue is coming.
-
October 22, 2024 at 11:22 am
Yannis
Ansys EmployeeHello,
This error is very generic and could indicate a number of issues. Most commonly, it can be a mesh issue but we would have to check the setup as well. It is difficult to comment on this without looking at the model. Please file a support request through the customer portal.
Kind regards,
Yannis
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- HFSS Incident Plane Wave excitement mode
- Ansys Maxwell 3D – eddy current
- dq graph non-conformity
- Simplorer+Maxwell Cosimulation results and Maxwell results mismatch
- Maxwell circuit – PWM
- Parametrizing coil “terminals” with coil geometry
- Difficulty/Obstacle: “Parasolid entry check failed for part:”
- Ansys-MATLAB Co-Simulation
- Plotting Ex, Ey and Ez in vector forms individually
- Calculating E-field tangential to a 2D resonant structure on a sapphire chip
Top Contributors
-
1962
-
886
-
599
-
591
-
366
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.