ICEM Mesh Distoration at First Layer Close to Wall
-
-
Dear All,
I am simulating a flow channel of a turbomachinery. No vane in the domain. The flow is in the radial-inward direction with a tilting angle in the meridional plane, as shown in Pic. 1.
In ICEM, I generated the structured mesh with manual blocking. The mesh quality and the general appearance of the mesh looks all good.
However, when the mesh is imported into CFX. The marker of the inlet boundary has an offset to each other, instead of staying in one line, as Pic 2.
Viewing 1 reply thread- The topic ‘ICEM Mesh Distoration at First Layer Close to Wall’ is closed to new replies.
-
You are navigating away from the AIS Discovery experience