ICEM geometry problem

- August 16, 2023 at 7:50 am
  
  Xiong Lie
  Subscriber
  
  Hi experts!
  My model is a thin and long spiral coil, the coil geometry model was created in SolidWorks, saved as STEP format and then imported into icem, but it turns out that the arc of the coil in icem is made up of many straight segments, why is that?
- August 16, 2023 at 12:12 pm
  
  Essence
  Ansys Employee
  
  Hello,
  You do not need to worry about that. It might be due to graphics issue on your system. You can proceed with the meshing. No issues.