I wanted to verify my geometry.
-
-
Hi,
I'm looking at wind loading on rooftop located solar panel. I wanted to ask if my geometry was correct for the modelling. This looks like what I want but functionally is there anything I should do? Should I separate the solar panel and building as two solids? What are some best practices for geometry creation so I can mesh this easily and get accurate results? I have not created my fluid domain yet but its just an enclosure with domain dimensions taken from literature. I'm asking this because my previous model was a real pain to mesh and did not mesh properly so I started from scratch again. Can someone guide me on meshing this? This is a single solid.
Viewing 1 reply thread- The topic ‘I wanted to verify my geometry.’ is closed to new replies.
-
You are navigating away from the AIS Discovery experience