I can’t open ‘Design Modeler’ on my Ansys Workbench 2022 R2

- March 16, 2023 at 5:15 am
  
  Mert Mutlu
  Subscriber
  
  Hello for everyone,
  I've started to learning Ansys Workbench, but when I am trying to do new static structural analysis I can't create geometry. When I right-click on geometry tab, there is no 'Design Modeler' section. I changed the 'Preffered Geometry Editor' as Design Modeler but still I can't find any Design Modeler choice on geometry tab.
- March 16, 2023 at 2:25 pm
  
  Ashish Khemka
  Forum Moderator
  
  Hi,
  Please see if the following link helps:
  Design modeler not working (ansys.com)
  Regards,
  Ashish Khemka
  - March 16, 2023 at 8:43 pm
    
    Mert Mutlu
    Subscriber
    
    Hello dear Khemka,
    As you seen which I attached images, there is no Design Modeler section on my Ansys. Either right-click or double clicking the Geometry tab even my Design Modeler don't open. My issue is not similar to this problem. I have to handle this problem, and I couldn't find any solution for this.
- March 17, 2023 at 8:50 am
  
  Rahul Kumbhar
  Ansys Employee
  
  Hi Mert Mutlu,
  This might need to upgrade license manager. Or try installing Ansys 2023R1.
- February 7, 2024 at 12:44 pm
  
  Hamed Noori
  Subscriber
- February 7, 2024 at 12:44 pm
  
  Hamed Noori
  Subscriber
  
  Hello,
  
  I have the same exact problem (2024 version, static analysis), but my license is premium (trial license). Could you help on this matter?
  
  Regards,