-
-
November 21, 2023 at 10:36 amCORMAC JAMES MCCUMISKEYSubscriber
When I input my solidworks geometry into ansys workbench and open discovery the coordinate system is off centre. I was wondering If it was possible centre the global coordinate system.
Â
-
November 23, 2023 at 1:22 pmCFD_FriendAnsys Employee
Hi Cormac,
You can use the "Move" tool and move the body such that the origin is centered within the body.Â
-
Viewing 1 reply thread
- The topic ‘How to change the coordinate system in Ansys Workbench’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- error udf
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- Fluent fails with Intel MPI protocol on 2 nodes
- Cyclone (Stairmand) simulation using RSM
- Diesel with Ammonia/Hydrogen blend combustion
- Non-Intersected faces found for matching interface periodic-walls
- Mass Conservation Issue in Methane Pyrolysis Shock Tube Simulation
- Encountering Error in Heterogeneous Surface Reaction
- How to obtain axial and tangential velocity in CFX-post?
Top Contributors
-
1141
-
471
-
468
-
225
-
201
Top Rated Tags
© 2024 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.