How do I create a section plane in CFD post?

- November 3, 2021 at 9:18 pm
  
  lyonsp4
  Subscriber
  
  Hello, I am a complete beginner to ANSYS and have recently completed my first 3D simulation of a countercurrent heat exchanger. I was wondering, is there a way to produce a section plane on this result so that I can cut the result down the middle and still retain the 3D appearance instead of just a flat plane? I would like to keep the model with the 3d look like the bottom image, not like the top image.
- November 9, 2021 at 9:28 am
  
  Amine Ben Hadj Ali
  Ansys Employee
  
  I do not understand the requirement but are you trying to create a cut plane: then create a x based plane (Plane YZ in Ansys Fluent).