-
-
August 14, 2024 at 8:12 am
Abdurahman Al-Jarrah
SubscriberDear All,
In my simulation case, I am simulating a large CAD model that is highly turbulent, and the solution diverges continuously, I am using the Viscous SST-K omega model for my simulation in fluent, if you have any recommendations to make my solution converge this will be appreciated.
Best Regards.
Abdurahman Aljarrah.
Â
-
August 14, 2024 at 9:08 am
Rob
Forum ModeratorAssuming the mesh (and cells) are good, are the models and boundary conditions physically sensible and have you checked the initial condition makes sense?
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- How do I get my hands on Ansys Rocky DEM
- Non-Intersected faces found for matching interface periodic-walls
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Script Error
- Facing trouble regarding setting up boundary conditions for SOEC Modeling
- convergence issue for transonic flow
- Running ANSYS Fluent on a HPC Cluster
- Point exception in erosion calculation
- Errors with multi-connected bodies using AQWA
Top Contributors
-
1952
-
880
-
599
-
591
-
366
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.