-
-
August 2, 2024 at 5:53 am
diett004
SubscriberI have a colleague that has been making and running an assortment of horn and lens models on Xeon processors. When I run the same models on AMD 7763 processors, I see memory requirements of 4 to 7 times what my colleague requires. Does anyone know why this might be happening and, if possible, how to fix it?
-
August 12, 2024 at 9:33 pm
Rong Liu
Ansys EmployeeHI, Sam,Â
Â
You can get the profile file from the simulation and compare it with your colleague line to line, that will give an answer to the memory.Â
Profile file can be obtained after simulation by right click on Setup under Analysis in Project manager and choose Profile.
Â
Best regards,
Rong
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- HFSS Incident Plane Wave excitement mode
- Ansys Maxwell 3D – eddy current
- dq graph non-conformity
- Simplorer+Maxwell Cosimulation results and Maxwell results mismatch
- Parametrizing coil “terminals” with coil geometry
- Maxwell circuit – PWM
- Ansys-MATLAB Co-Simulation
- Plotting Ex, Ey and Ez in vector forms individually
- Difficulty/Obstacle: “Parasolid entry check failed for part:”
- Calculating E-field tangential to a 2D resonant structure on a sapphire chip
Top Contributors
-
1952
-
880
-
599
-
591
-
366
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.