-
-
June 5, 2024 at 8:21 am_antonis_Subscriber
Hello,
I am running an FSI simulation of an ascending thoracic aorta. I want to post-process the results of Fluent, but in specific locations. Specifically, I made extended tubes at the inlet and outlets, and I want the visualization to keep only the part of the aorta without the tubes. Is there a way to pick specific nodes in Fluent?Thank you,Â
Antonis
-
June 5, 2024 at 4:27 pmRobForum Moderator
There are clip options for the surfaces, so clip by position or limit to certain cell zones.Â
-
Viewing 1 reply thread
- The topic ‘FSI simulation of aorta’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- Non-Intersected faces found for matching interface periodic-walls
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- error udf
- Cyclone (Stairmand) simulation using RSM
- Diesel with Ammonia/Hydrogen blend combustion
- Mass Conservation Issue in Methane Pyrolysis Shock Tube Simulation
- Fluent fails with Intel MPI protocol on 2 nodes
- Encountering Error in Heterogeneous Surface Reaction
- Script Error
Top Contributors
-
1161
-
488
-
486
-
225
-
201
Top Rated Tags
© 2024 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.