FSAE Carbon Monocoque Torsional Rigidity Model

- January 23, 2025 at 4:23 am
  
  Jonathan Cloutier
  Subscriber
  
  Hello,
  I have been working on the FSAE Carb. Monoqocue course and have run into a problem. When creating the face mesh I am met with an error that the face mesh could not be created. When locating the error, I find it to be this corner (pictures 1 & 2) which does not have perfect alignment on either side. In the videos, this is not a problem. I am not very comfortable using SpaceClaim (i am new to this) and therefore do not know how to fix this issue. I believe not incorporating this section in the face mesh results in the top portion of the car not being shown when entering 'Setup'. Any help would be appreciated.
- January 23, 2025 at 7:44 am
  
  Erik Kostson
  Ansys Employee
  
  Hi
  I do not experience such an issue (2024 R2) - follow the instructions on alll videos and it should be fine.
  Erik