TAGGED: -Ansys-Maxwell-electronics, simulation
-
-
October 7, 2024 at 6:36 pm
ethanwg
SubscriberI am attempting to find the voltage at a point or average voltage across a surface. How would I go about getting that in the fields calculator in Ansys Maxwell3D?
-
October 11, 2024 at 8:19 pm
MirandaH
Ansys EmployeeHi, you can place a marker on the geometry in voltage field overlay to get voltage at a point. For average voltage across a surface, you can use field calculator.
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- HFSS Incident Plane Wave excitement mode
- Ansys Maxwell 3D – eddy current
- dq graph non-conformity
- Simplorer+Maxwell Cosimulation results and Maxwell results mismatch
- Parametrizing coil “terminals” with coil geometry
- Maxwell circuit – PWM
- Ansys-MATLAB Co-Simulation
- Plotting Ex, Ey and Ez in vector forms individually
- Difficulty/Obstacle: “Parasolid entry check failed for part:”
- Calculating E-field tangential to a 2D resonant structure on a sapphire chip
Top Contributors
-
1942
-
865
-
599
-
591
-
366
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.