Learning Forum

[qjaxod13]

Hello,

I am using the Ansys 2024 R1 student license.

I want to generate a computational mesh using pyAnsys Geometry.

As shown in the attached image, I want to connect each line and then rotate it 360 degrees around the Z-axis.

However, when I run the code, I can only plot the sketch, and then it terminates with the following error message.

Is there a limitation in the 24R1 license that restricts the use of functions like revolve or sweep?

Thank you.

[Devendra Badgujar]

Hello Bumjin,

You can see in the error it is poissble in 24.2 version. The APIs are new and supported with 24.2.

Revolve sweep is not available and requires minimum 24.2 version. 

Thanks, 

Devendra