TAGGED: laser-diode
-
-
December 2, 2024 at 6:28 am
-
December 6, 2024 at 11:01 am
Niki Papachristou
Ansys EmployeeHi Subscriber,
Thank you for reaching out to us! I would suggest to go through our KBAs and tutorials on how to achieve your desing. This might be a good start to understand how to initial set up your desing: How to design a singlet lens, Part 1: Setup,but you can also go through Laser & Fibers to understand how to set up your gaussian beam. This article: How to work in global coordinates in a sequential optical system to understand on how to built a prism within sequential mode. Finally, we have several sample files within zemax installation folders, where you can find examples to open ansd test:
I hope that was helpful, but feel free to come back to us at any point with any additional questions.
Kind Regards,
Niki
-
- You must be logged in to reply to this topic.
-
3442
-
1057
-
1051
-
917
-
896
© 2025 Copyright ANSYS, Inc. All rights reserved.